Site icon Master Organic Chemistry

Allylic Bromination

In previous posts on radicals, we’ve seen how bromine can selectively react with tertiary C-H bonds (bond strength 93 kcal/mol) over secondary (96 kcal/mol) and primary (100 kcal/mol) C–H bonds.

If you recall that bond dissociation energies are a good guide for predicting radical stability, then you won’t be surprised to learn that “benzylic” and “allyllic” C–H bonds can also be brominated selectively. These C-H bonds are particularly weak because the radical formed through the homolytic  breaking of C-H  is stabilized by resonance.

How might these reactions work? For benzylic bromination, hopefully imagining the mechanism will be straightforward: after initiation (by heat or light), bromine radical then breaks the C-H bond (forming the benzylic radical) [propagation step #1] and the benzylic radical attacks Br2 to re-generate bromine radical [propagation step #2]. These two steps repeat until the concentration of Br2 runs low, whereupon radical chain termination will occur.

Full mechanism here.

Let’s turn to allylic bromination. Do you see any reason why treating the molecule below with Br2 might lead to problems?

You might recall that alkenes react with Br2 to form vicinal dibromides, and that is in fact exactly what would occur if we were to just dump in 1 equivalent of Br2 with an alkene.

At issue here is the fact that we have 1 equivalent of Br2 swimming around, of which only a small proportion at any given time will exist as bromine radical [due to the initiation step]. How might we solve this problem and favour the radical substitution over the dibromination.

Imagine, if you will, we had a very low concentration of Br2. If the concentration of Br2 is kept low, not only will the rate of dibromination be lower, the relative rate of bromine radical relative to Br2 will increase. Therefore, the rate of C-H abstraction relative to dibromination will increase, which will allow our allylic bromination product to be formed in a higher yield. *

Of course, this creates a new question: how do we generate a low, constant concentration of Br2?

As it turns out, there’s a way. If the bromonium ion source N-bromosuccinimide (NBS) is present with a trace amount of acid (HBr), HBr will react with NBS to give succinimide and Br2.**

Since one equivalent of HBr generates one equivalent of Br2,  Br2 will be generated only after the completion of Propagation Step #1.*** This keeps the concentration of Br2 low and allows the free-radical reaction to out-compete the alkene addition reaction.

In all other respects the allylic bromination reaction is identical to the benzylic bromination reaction mechanism shown above. However in *some* situations there is an extra twist, which we will briefly discuss in the next post.

Next Post: Allylic Rearrangement

*  If this explanation sounds somewhat unsatisfactory, you’re on to something. After all, doesn’t this decrease the concentration of Br• as well? One additional complication is that theoretical studies show strong evidence for a termolecular rate determining step in formation of the bromonium ion (that is, involvement by the alkene and two molecules of Br2). Decreasing the concentration of Br2 would therefore vastly decrease the rate of bromonium ion formation (and thus dibromination) relative to free radical halogenation.

** As it happens, NBS which has been left out for awhile will usually be contaminated with trace HBr (as well as Br2, which gives it a yellow or orange colour). For this reason if doing a radical reaction with NBS it’s common to avoid recrystallizing it before use, as it will remove the trace acid that jump starts the reaction in the first place.

*** As long as the initial concentration of HBr is low (i.e. it is used as a catalyst)


Related Posts:

Exit mobile version